2001 Ford F-150 Cylinder Head DISASSEMBLY AND ASSEMBLY
download Cylinder Head Special Tool(s) Compressor, Valve Spring 303-567 (T97P-6565-AH) Spacer, Valve Spring Compressor 303-382 (T91P-6565-AH) Installer, Valve Stem Oil Seal 303-383 (T91P-6571-A)...
View Article1998 Ford Expedition Main Control Valve Body Removal Installation
download 1. If equipped, turn the air suspension switch OFF. 2. Disconnect battery ground cable. 3. Raise and support the vehicle; refer to Section 100-02. 4. Drain transmission fluid and remove the...
View Article2001 Ford Escort Cylinder Head Disassembly
download 1. Remove the bolt and the camshaft position (CMP) sensor. 2. Remove the bolts, the rocker arm seats, and the rocker arms. 2. Remove the bolts, the rocker arm seats, and the rocker arms. 3....
View Article1993 Mercury Villager LS MANUFACTURER’S SUGGESTED SCHEDULED MAINTENANCE
download For 1993, the manufacturer recommends the belt be replaced every 60,000 miles. For 1994-98, the manufacturer recommends the belt be replaced every 105,000 miles. Installation 1. Ensure...
View Article2001 Chevrolet Cavalier Idle Air Control Motor (IAC): Service and Repair...
download 1. Remove the idle air control (IAC) valve connector. 2. Remove the IAC valve attaching screws (1). NOTE: If the IAC valve has been in service: DO NOT push or pull on the IAC valve pintle. The...
View Article1996 Ford Taurus valve body Removal and Installation
download REMOVAL NOTE: The oil pump and valve body are removed as an assembly. 1. Disconnect battery ground cable, then remove battery, battery tray, and remote air cleaner. 2. Position supply hoses,...
View Article2005 Chevrolet Malibu Vacuum Brake Booster Check Valve and/or Hose...
download 1. Disconnect the brake booster vacuum check valve (1) from the brake booster. 2. If the vacuum check valve (1) needs to be separated from the vacuum hose (3), release and reposition the clamp...
View Article1995 Ford Windstar VALVE CLEARANCE ADJUSTMENT
download NOTE: Hydraulic valve lifters are used; no valve adjustment is required. When valve and/or valve seat is machined, valve clearance is reduced and may cause improper valve operation. Different...
View Article1992 Suzuki Swift VALVE CLEARANCE ADJUSTMENT
download NOTE: Samurai & Sidekick 1) Remove rocker cover. Rotate crankshaft until zero degree (TDC) timing mark of timing belt cover is in line with timing mark on crankshaft pulley. 2) Cylinder...
View Article2004 Jeep Grand Cherokee Limited DIAGNOSIS AND TESTING – VACUUM RESERVOIR
download 1. Disconnect vacuum hose at speed control servo and install a vacuum gauge into the disconnected hose. 2. Start engine and observe gauge at idle. Vacuum gauge should read at least ten inches...
View Article
More Pages to Explore .....